Next steps
Manufacturer and catalog specs Brand first setting
Recommended ranges for this filament from the brand/catalog — a solid first setting, usually better than a slicer Generic PLA. Community calibrations refine flow, PA and printer-specific behaviour when someone has measured them.
- Nozzle °C
- — – — °C
- Bed °C
- — – — °C
- Chamber °C
- — – — °C
- Preheat °C
- — °C
- Drying
- — °C / — h
- Shrinkage XY % / Shrinkage Z %
- — / —
- Diameter
- 1.75 mm
- Density
- 1.27 g/cm³
- Min nozzle
- — mm
- Shore A / Shore D
- — / —
- Abrasive
- no
- Colour
- #1858A0
Community recommendation
No community measurements for this colour yet. Use the manufacturer specs and starter download below — they are already a strong first setting. Contribute a calibration when you have measured values.
Calibration profiles
Starter profile from manufacturer data
Built from this filament’s brand/catalog temperatures plus a printer-class template. That is usually a stronger start than a slicer Generic PLA. Not community-measured yet — fine-tune before critical prints, and share your calibration when you can.
Catalog identity is hosted on OpenFilament. Some rows were originally seeded from the Open Filament Database (MIT). openfilamentdatabase.org